Reversing the Entire Production Order Consumption in Microsoft Dynamics NAV 2013

(Without Keying in the items One by One)

Occasionally there is a mistake made where Production Order Consumption is posted.  It is quite easy to fix the problem if there are only one or two lines that need to be reversed, but what if the entire consumption needs to be reversed for tens or hundreds of items on a single Dynamics NAV Production Order?

In Dynamics NAV 2013 I created a Released Production Order for a Bicycle:

Figure 1 - Released Production Order for a Bicycle

I then used the Dynamics NAV Consumption Journal to Calculate and Post the consumption for the Production Order:

Figure 2 – Dynamics NAV Consumption Journal to calculate and post the consumption for the Production Order

After I posted the consumption, I realized that I had posted the consumption for the wrong order, and I need to reverse all of the consumption for this order.

I could open up the Consumption Journal and type in all of the items and the quantities.  This might be OK if there were only a few lines, but what if there were a hundred?

Here is the trick:

Open up the Consumption and then select “Calculate consumption”. Simply select “OK” and let it calculate.  The trick is to select the calculation based on “Actual Output”:

Figure 3 – Edit the Consumption Journal->Calculate Consumption and set the calculation based on “Actual Output”

Now, when using Actual Output, you can see that the quantities are all negative:

Figure 4 – Consumption Journal showing negative quantities

And you can see that the component lines of the Production Order are returned to the original state:

Figure 5 – Component lines of the Production Order are returned to the original state

Read more blogs by Bob Bergman for practical advice on using Microsoft Dynamics NAV.

If you would like more information on this subject or another Dynamics NAV Manufacturing subject, please contact ArcherPoint.